Parkell Sensimatic® D700SE Electrosurge - 110V

Efficient, Precise Tissue Management

Simplifying and improving the treatment outcomes of the procedures performed every day in your dental office, the Sensimatic 700SE cuts faster than a diode laser and produces less bleeding and better visibility of the treatment site than a scalpel

• Monopolar for the precise cuts.
• 10 power settings.
• 3 cutting modes; CUT, CUT/COAG, and COAG.
• Electrode wire can be adjusted to meet clinical contour needs.
• Operating frequency: 1.4 - 1.7 MHz.
• Maximum Power Output: 50 watts.

 
Advantages of Electrosurgery Over a Diode Laser

• Thin wire electrodes can be adjusted to meet clinical contour needs.
• The side of the electrode wire can cut in addition to the tip (Only the tip is an active cutting surface for a diode laser).
• Procedures are completed in a fraction of the time it takes to perform the same procedure with a diode laser.
• A wider, more versatile range of cutting tips.
• Lower initial device cost.

 
PLEASE NOTE: The handpiece (D702) and indifferent plate cable (D703) are only compatible with Sensimatic units (D700SE-110) w/ serial numbers #90000 and higher, and (D700SE-230) w/ serial numbers #80000 and higher. Please check the serial number located on the bottom of your unit before ordering accessories.

Includes:

• (6) Different Electrodes**; Scalpel Point—T2, Large Loop—T5, Vertical Loop—T8, Horizontal Loop—T16, Hemostasis Ball—C3, Troughing Point—AP1.5
• (1) Foot switch
• (1) Handpiece and cable
• (1) Indifferent Plate and Cable
• Instructions for Use

** Electrode Shaft Size: 1/16”

Buy $200 worth of Parkell Products and get 1 Dexiter Front Service Mirror Box/12 FREE

OR Buy $500 worth of Parkell Products and get 3 Dexiter Front Service Mirror Box/12 FREE